Fast, Reliable Spray Foam Insulation Across Richland Hills
If you’re in Richland Hills living in a brick ranch built between 1955 and 1975, there’s a good chance your attic insulation has quietly failed. Those original fiberglass batts, usually 3 inches thick, have settled and compressed over 50 or 60 Texas summers. They’re now doing the work of R-8 when Richland Hills heat demands R-38 or better. That’s why rooms over the garage stay hot at 9pm and your AC runs 14 hours a day in August. Our spray foam crews serve the whole Richland Hills area, from the neighborhoods off Rufe Snow Drive to Baker Boulevard and Glenview Drive, and we answer the phone live at (682) 233-8300 when you call.
Why Thistledown Insulation Fort Worth Is Richland Hills’s Preferred Spray Foam Insulation Company
We spend a lot of time in Richland Hills attics. Specifically, attics in single-story brick-veneer ranches built in the 1950s and 1960s, where the framing is generous but the original insulation was never enough. Our technicians know what they’re walking into on those jobs because they’ve worked on hundreds of them across the metro: settled batts, open soffits, rim joists that have never been touched, and transition walls between original construction and a 1980s addition where hot air pours in. That matters because we quote the real job, not a generic one.
Thistledown Insulation Fort Worth is part of the Cedarwell family of independently owned insulation companies, and we’ve been at this since 2003. Every Richland Hills customer gets the same standard: a written price before any work starts, background-checked uniformed technicians who lay drop cloths in your hallway and wear shoe covers from the front door to the attic hatch, and a photo of the clean-up before we leave. If something isn’t right, our 365-Day Done Right Promise means we fix it. No debate, no fine print. That’s the Cedarwell Care Promise in action, and it applies on every job we do in Richland Hills.
Closed Cell Spray Foam Insulation in Richland Hills
Closed cell spray foam is the right call for Richland Hills homeowners who need high R-value per inch plus structural strength and a vapor barrier in one product. In many Richland Hills ranches with pier-and-beam foundations, we apply closed cell foam to the rim joists and crawl space walls to stop humid Texas air from entering under the house. In an attic, closed cell gives you about R-6.5 to R-7 per inch, which means a 3-inch application on the roof deck can outperform the original R-11 batts by a wide margin while also sealing air leaks. A typical closed cell spray foam project on a Richland Hills ranch attic runs $4,800 to $9,500 depending on square footage and whether we’re insulating the roof deck or the attic floor.
Where We Install It
Rim joists are the first place we look in Richland Hills pier-and-beam homes. Unsealed rim joists let humid outdoor air move freely under the house all summer, which makes ductwork sweat and blows moisture up into the living space. Sealing them with closed cell foam usually costs $900 to $2,300 depending on access and linear footage. We also apply closed cell to garage ceilings when the room above is a bedroom, which is common in Richland Hills ranches where the garage was later converted or built with living space overhead.
Why Homeowners Choose It
Closed cell adds rigidity to the roof deck, which helps in storms, and it acts as a Class II vapor retarder. That matters with Richland Hills’s humid subtropical climate. Moisture control is half the insulation job here. The other half is heat gain, and closed cell handles both.
Open Cell Spray Foam in Richland Hills
Open cell spray foam is what we recommend for most Richland Hills attic floors in existing homes. It’s lighter, expands aggressively into gaps and odd framing, and gives about R-3.7 per inch. In a Richland Hills attic with settled R-8 batts, we’ll apply 10 to 11 inches of open cell across the existing floor, air-sealing the entire ceiling plane and bringing the assembly to R-38 or better. A typical open cell attic floor project in Richland Hills runs $2,800 to $5,400 for a 1,500 to 2,200 square foot ranch, and that includes removing or working around the old material in most cases.
What It Does For a Richland Hills Ranch
The big win with open cell is air sealing. The rim joists and transition gaps in older Richland Hills homes let humid outdoor air bypass insulation entirely, so even R-19 doesn’t perform at its rated value. Open cell fills those irregular gaps naturally while it expands. For a home built in 1968 off Glenview Drive with pier-and-beam, air-sealing the attic floor with open cell plus rim joist work typically drops July cooling load noticeably, because the AC no longer fights a constant stream of outside air.
Why Not Closed Cell Everywhere
Closed cell costs more per board foot and is overkill for many attic floor applications. Open cell gives you the air barrier performance needed at a lower installed cost. Our team will quote both and explain the tradeoffs, and you’ll have the written number before we touch a rafter.
Trusted Brands We Service in Richland Hills
We’re certified installers for several major spray foam manufacturers, and we match the product to the Richland Hills home rather than forcing one brand everywhere. For open cell work, we often use Icynene or Demilec products. For closed cell, CertainTeed and Demilec have strong options we regularly install. Having eight brands in our lineup, including Rockwool for specific applications, means we don’t have to stretch a single product to fit every situation. We keep inventory staged for Richland Hills jobs so scheduling moves quickly once you approve the written quote.
Common Spray Foam Insulation Problems We See in Richland Hills Homes
- Settled original fiberglass batts that mislead homeowners. The attic looks insulated, but 3-inch batts from 1962 have compressed to under R-8 over the decades. The rooms stay hot and the AC runs nonstop. We see this in nearly every original-condition Richland Hills ranch we enter.
- Unsealed rim joists and pier-and-beam crawl spaces. Humid air enters underneath the house all summer long. That moisture condenses on ductwork, and any insulation in the floor or attic fights a constant stream of infiltrating outside air. Spray foam on the rim joists stops that at the source.
- Bad retrofit spray foam at original-to-addition transitions. When a 1980s addition was built onto a 1955 house, insulation at the transition wall is often missing or inadequate. Closed cell or open cell foam applied properly at the transition stops a hot-air channel most homeowners don’t know exists. This is one of the biggest issues we remedy in Richland Hills.
- Compacted blown-in cellulose that isn’t the fix people think it is. Older Richland Hills homes often had cellulose blown in years ago, and it’s settled to R-19 or below. The problem is it air-seals nothing. We can install spray foam over or around settled cellulose after we diagnose the attic shell. This is a page-worthy topic on its own, which our Spray Foam Insulation team covers in detail.
Pricing for Spray Foam Insulation in Richland Hills, TX
Here’s what you can expect to pay for spray foam work in Richland Hills. Open cell attic floor application on a typical 1,800 square foot ranch runs $3,200 to $5,200. Closed cell rim joist sealing runs $900 to $2,300 for most pier-and-beam homes. Closed cell roof deck application runs $4,800 to $9,500 depending on square footage and depth. Garage ceiling spray foam, common when a bedroom sits above the garage, runs $1,200 to $2,800. Every quote is line-item and written before we start, and there’s no charge for the estimate. Call (682) 233-8300 and we’ll schedule a visit to your Richland Hills home.
We Also Serve Cities Near Richland Hills
Our crews regularly work throughout the northeast Tarrant County area. Along with Richland Hills, we serve homeowners in Fort Worth, Haltom City, Benbrook, and Keller. If you’re in one of those communities and need spray foam, the same written price and Cedarwell Care Promise protect every job. Call us and we’ll get you scheduled.
Serving Richland Hills, TX - Our Local Coverage Area
We’re based in the Richland Hills area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Spray Foam Insulation in Richland Hills
Yes, and it’s one of the best retrofits for a 1960s Richland Hills ranch. The original fiberglass batts have likely settled to R-8 or lower, and spray foam air-seals the entire attic floor while adding R-38 or more. You get the air-sealing and the thermal barrier in one step. Call (682) 233-8300 for a free attic evaluation and written quote.
Pier-and-beam homes in Richland Hills pull humid outside air in through unsealed rim joists, and that moisture travels upward into the attic and living space. Open cell spray foam on the attic floor air-seals the ceiling plane, and combined with rim joist closed cell sealing, it stops the air bypass that defeats traditional insulation. The result is a cooler, drier attic and lower humidity in the house.
Yes. We can work around or over settled blown-in cellulose in a Richland Hills attic. We’ll first inspect the attic shell and rim joists to identify air leaks, then apply open cell spray foam across the attic floor to bring total R-value to R-38 or higher. The foam also air-seals the assembly, which the cellulose alone cannot do. We’ll quote the exact plan in writing before work begins.
For a Richland Hills roof deck, we recommend 5 to 6 inches of open cell spray foam to reach R-20 to R-22 at the roofline, or 3 to 4 inches of closed cell for R-21 to R-26 plus a vapor retarder. The right depth and product depends on whether the attic has ductwork and whether you’re conditioning the attic or leaving it ventilated. We’ll spec that out specifically for your home.
The transition between original construction and a later addition is a common air and heat leak in Richland Hills ranches. We apply spray foam directly to the framing at the transition wall and the ceiling plane above it, closing the gap that lets hot attic air pour into the living space. On a recent job on a brick-veneer ranch off Rufe Snow Drive, our crew found the original 3-inch fiberglass batts compacted to under R-8 and no insulation at the transition wall. We air-sealed the rim joists and transition framing, then applied open-cell spray foam across the entire attic floor to bring it to R-38, cutting the homeowner’s July cooling bill by nearly a third.
Call Thistledown Insulation Fort Worth for Spray Foam in Richland Hills
If your Richland Hills home is hot in summer, humid, or running the AC around the clock, your attic is the most likely culprit. We’ll come out, inspect it the right way, and give you a written price for exactly what your house needs, no ranges, no surprises. Thistledown is the soft fluff of the thistle, one of nature’s lightest insulators. The name is a promise about how carefully we work. Call (682) 233-8300 today and talk to a live person, any time.
Written by Neil Barron, Owner at Thistledown Insulation Fort Worth, serving Richland Hills and the surrounding metro.